如何才能避免拉力机操作的时候没有噪音

How can we avoid the noise when the drawing machine is operating?

以下是特斯特对传动噪音大的问题总结了一些原因及解决办法：

The following is the text of the transmission noise of the summarizes some of the causes and solutions:

1.轴承如果有损坏，有轻微的震动，运行不平稳，这就必须要更换轴承

1. bearings if there is damage, there is a slight vibration, uneven running, it must replace bearings

2.拉力机上面的滚珠丝杆力过紧或者过松，应该调为刚刚好。轴向窜动值误差不大于0.005mm

2. the tension of the ball screw on the tension machine is too tight or too loose, it should be adjusted to just right. Axial drift error is not greater than 0.005mm

3.拉力机的滚珠丝杆有损坏，应该及时的维修或者更换。

3. the ball screw of tension machine is damaged and should be repaired or replaced in time.

4.拉力机的导轨润滑油不够多，可以加润滑油，排除故障。

4. tension machine guide rail, lubricating oil is not enough, you can add lubricating oil, troubleshooting.

5.电机未调整好，增减过大，那就必须调整电机的控制系统

5., the motor is not adjusted, or increase or decrease too much, it must adjust the motor control system

电子拉力试验机可以在受控的速度下对塑料样条进行伸展、弯曲、压缩或穿刺，直至它们断裂，从而测得抗拉强度、弯曲模量、抗弯强度、穿刺强度、断裂延伸率等等力学性能指标，应用于塑胶行业的电子拉力试验机也专称为塑胶拉力机。它们是在塑料配混厂家实验室中最为常见的仪器之一。

Electronic tensile testing machine can be controlled in the speed of plastic spline to stretching, bending, compression or puncture, until they break, thereby measuring the mechanical properties of tensile strength, flexural modulus, flexural strength, puncture strength, elongation, electronic tensile testing machine used in the plastic industry also specifically called plastic tensile machine. They are among the most common instruments in a plastics mixing manufacturer's laboratory.